Tan enamel reactor cold spray enamel equipment and thermal spray enamel difference now enamel enamel spray equipment industry can be divided into two categories: cold spray (powder) and thermal spray (powder). Most northern enamel equipment manufacturers typically use cold spray technology, and South enamel equipment manufacturers are mostly using thermal spray technology. Below Talking about the difference between hot and cold spray and the pros and cons: quality enamel equipment in addition to the quality of a relationship with the enamel, but also with enamel coating technology chosen device has an important relationship. In simple terms, rough cold spray enamel work is dusting equipment at room temperature, the cooling state of 3000l reaction tank, thermal spray operations are dusting rough enamel device without completely cooled state is reached can work performed. Cold spray again to facilitate workers and fine grinding operations on steel billets and ceramic powder and ceramic powder in water naturally dry, thin porcelain under this technical work (effective thickness large), firing several times more than the cost high; thermal spray equipment at the time of the enamel is not fully carry out work on cooling, enamel porcelain powder in water through the cooling plate is not forced drying so fast cyclical, equipment production, but also because of the problem of temperature, thermal spray only For every manufacturing defect coverage operations, unable to fine grinding, so its equipment porcelain enamel layer is thick, relatively low cost. Enamel reactor technology for a comprehensive analysis of the reaction vessel, such as reaction time, temperature, loading factor, material contraction ratio, feed ratio, conversion rates, changes in status, and feeding materials and reaction products of physical data, chemical properties, and so on. Calculate enamel reactor, glass-lined reactor volume 4000l enamel reaction tank, according to the user needs to determine the reactor diameter and height of the cylinder, sealing top. And heat transfer area is calculated and checked. Because after several glass-lined reactor is fired at 900 ℃ high temperature of from about 12,500 glass-lined reactor, at the high temperature and low carbon steel or low alloy steel ordinary low stiffness, easily deformed, in fact , glass-lined equipment deformation in the manufacturing process are mainly occurring at this time. For smaller deformation during cooling can be baked to make appropriate correction and assurance form tolerance in the workpiece, for the large deformation can not be corrected. Therefore, glass-lined equipment should not only consider the strength and stiffness under normal operating conditions, should be considered at high temperature stiffness enameling process, and in most cases, the latter controlling factor. 10000l reaction tank | Cheng Ming Chemical (certified) | reaction tank provided by the Chemical Equipment Co., Ltd. Shandong Cheng Ming. Chemical Equipment Co., Ltd. Shandong Cheng Ming (www.cmchemical.net) is an industry leader in Shandong Zibo, chemical equipment, over the years, the company implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Cheng Ming Chemical leadership in the staff warmly welcome all inquiries negotiations to create Cheng Ming chemical a better future.